Aztech WIPC401 Setup Manual

Aztech WIPC401 Aztech WIPC401
Aztech Aztech WIPC401 WIPC401
Wireless N IP Camera
How to set Port Forwarding on Dlink How to set How to set How to set Port Forwarding on Dlink Port Forwarding on Dlink DCM Port Forwarding on Dlink
1. Connect your Aztech WIPC401 into your Modem/Router's Ethernet LAN port with an Ethernet cable.
Make sure that your Modem/Router's Internet connection is UP, to allow you to access your IP
camera via the Internet.
2. Connect the Power adapter to your Aztech WIPC401 and plug it into the power out then switch it ON.
3. Connect your computer to the same router wherein your Aztech WIPC401 is connected.
Ensure that the DDNS information was set properly on the IP camera if you are using a Third
Party DDNS else use the Manufacturer's DDNS.
4. Launch the Internet browser on your computer and input 192.168.0.1 then type admin
username and password password for the password*. This will launch your Router's WEB User Interface. password password
F R E Q U E N T L Y A S K E D Q U E S T I O N v 1 . 0
S i n g a p o r e
DCM- - - - 604 DCM DCM 604? ? ? ? 604 604
admin for the
admin admin
A Z T E C H T E C H N O L O G I E S P T E L T D