Service Menu; Miscellaneous Commands - Digital Projection E-Vision 7500 Series User Manual

Digital Projection
E-Vision 7500 Series
<operation> <command>

SERVICE menu

model ?
ser.no ?
sw.ver ?
pixel.clock ?
signal ?
h.refresh ?
v.refresh ?
lamp1.hours ?
lamp2.hours ?
proj.runtime ?
blue.only = ?
fact.reset (execute)

Miscellaneous commands

power.on (execute)
power.off (execute)
status ?
errcode ?
Rev D July 2014
THE OPERATION COMMANDS
...continued from previous page
<values>
<string>
<string>
<string>
<string>
<string>
<string>
<string>
<string>
<string>
<string>
0 = Off
1 = On
0 = standby
1 = warm up
2 = imaging
3 = cooling
4 = reset
<string>
Notes
In MHz
Not applicable in STANDBY mode or without signal
locked.
Not applicable in STANDBY mode or without signal
locked.
Not applicable in STANDBY mode or without signal
locked.
Not applicable in STANDBY mode or without signal
locked.
Factory reset
Power on
Power off (puts projector into Standby mode)
Returns an error code - refer to the Error Codes
section below.
Remote Communications Guide
Notes
67