›
Remove the cap of the light in the direction of arrow
›
Remove the faulty bulb from the holder in the direction of the arrow
›
Insert a new bulb into the holder.
›
Clip in the cap of the lamp counter to the direction of arrow
›
Reinsert the lamp in the opposite direction to the arrow
›
Push on the light until the spring clicks into place.
Check that the light is securely inserted.
›
Shut the boot lid.
Rear Light
Fig. 195 Remove light / pull out connector
Read and observe
and
Removing
›
Open the tailgate.
›
Unscrew the screws
with the screwdriver from the tool kit
A
›
Grasp the light and remove carefully in direction of arrow
the pin
.
C
›
Press the latch
on the holder in the direction of the arrow
B
›
Press the latch in the direction of arrow
rection of arrow
.
4
Fitting
›
Insert the bulb holder into the lamp.
›
Tighten the lock in the opposite direction to the arrow
›
Insert the lamp with the holes
» Fig. 195
in the body.
›
Carefully press the light into the pins on the bodywork
192
Do-it-yourself
.
4
.
4
.
1
on page 186 first.
» page
» Fig. 195
1
2
and pull out the holder in the di-
3
» Fig.
2
» Fig. 196
on page 192 onto the pins
B
»
.
Ensure that the wiring harness does not become pinched between the body
.
and the lamp.
5
›
Screw the light into place
CAUTION
Ensure that the wiring harness does not become pinched between the body
■
and the lamp when it is being refitted – risk of damage to the electrical instal-
lation and risk of water ingress.
If you are not sure whether the wiring harness has become pinched, we rec-
■
ommend that you have the light connection checked by a specialist garage.
Ensure that the vehicle paintwork and the tail lamp are not damaged when
■
removing and installing the tail lamp.
Replacing bulbs in rear light
Fig. 196 Outer part of the lamp / removing the bulb / lamp holder
Read and observe
168.
from
Changing the bulb in the outer part of the lamp
›
Turn the holder with the bulb
.
›
Remove the socket with the bulb from the lamp housing in the direction of
arrow
.
2
›
Jiggle the bulb to remove.
›
Insert a new bulb into the socket.
›
Reinsert the holder with the bulb into the lamp housing and turn in the op-
posite direction of the arrow
195.
C
Changing the bulb in the inner part of the lamp
›
Turn the holders with the bulbs
›
Remove the holders with the bulbs from the lamp housing in the direction of
the arrow
.
2
and
on page 186 first.
in the direction of the arrow
A
to the stop.
1
in the direction of the arrow
A
» Fig.
196.
1
» Fig.
196.
1