Hamilton Beach change-a-bowl Instructions Manual page 5

840140800 Ev01.qxd
Using Your change-a-bowl
1. Make sure the Control Switch is
turned OFF and the unit is
unplugged.
2. Align Food Chute with opening on
motor. Push food chute through hole
until it locks in place.
3. Put Slice/Shred Disc or Fine Shred/
Crinkle Cut Disc on motor post with
the desired side facing up toward
the cover. Screw the Disc Lock
tightly onto motor post.
NOTE: The Fine Shred/Crinkle Cut
Disc is an optional accessory avail-
able with selected models. See page
4 for ordering information.
8/1/05 1:58 PM Page 5
4. Insert GladWare ® bowl (6 cup) into
processing bowl. Make sure the lid
of the GladWare ® bowl has been
removed. The Permanent Bowl may
also be used without the GladWare
bowl for processing.
5. Place cover and motor on top of
Permanent Bowl and turn clockwise.
To lock:
6. Place a hand on a tab on
each side of Permanent Bowl. With
a thumb on the top of the tab and a
finger on the bottom tab of each
side, turn clockwise.
NOTE: The unit will not work unless
the cover is locked into position.
(continued on next page)
™
®
5