Snom SoHo Getting Started Manual

SoHo Getting Started Guide

Important! Read the configuration instructions on

Page 2 before calling technical support!

Step 1.

Install the Device

1. To install the SoHo device into a wall

outlet, insert the appropriate plug adapt-

er into the device (A), then plug it into

the wall (B). Continue to Step 3.

2. To install the device on a flat, horizontal

surface, insert the plug fixture into the

device (A), insert the power cord into

the plug fixture (B), then plug the power

cord into an outlet (C).

3. Confirm that the green LED is lit. This

indicates that output is present.

4. Insert the Ethernet cable into the Ether-

net port on the SoHo device.

5. Insert the other end of the cable into a

switch/hub or to a PC/laptop.

Table of Contents

Do you have a question about the SoHo and is the answer not in the manual?

Page 1 Page 2 before calling technical support! Step 1. Install the Device 1. To install the SoHo device into a wall outlet, insert the appropriate plug adapt- er into the device (A), then plug it into the wall (B). Continue to Step 3.
Page 2 Step 2. Configure the Device The snom ONE SoHo must be configured with an IP address. Configuration of the IP address can be done using the following methods: • Method 1 (for router/switch configurations): If you have a DHCP server, connect the de- vice to your network, and your DHCP server will assign an IP address to it.
Page 3 81 and cannot be accessed without it). http://192.168.255.24:81 2. Log in using the following login credentials: User: admin Password: snomONE Step 4. Update the Device Important! Updating the SoHo is critical after initial setup of the device. 1. Click Admin. Page 3...
Page 4 2. Click Update and follow the steps to receive the latest updates. Copyright © 2011 snom technology, Inc.—All rights Internet reserved. This document is supplied by snom technology. No ADSL / Cable part of this document may be reproduced, repub- lished or retransmitted in any form or by any means...