Chapter 1 - Perimeter Wire Setup; Preparations; Planning The Setup - Robomow RM200 Operating & Safety Manual

1.1 Preparations


Read carefully the Operating and Safety Manual prior to setup.

It is recommended to mow your lawn using a conventional lawn mower and water the ground before
starting the setup for easier driving of the pegs.

Confirm all parts for the setup are included (refer to 'What's in the Box' page 9).

During the setup you will also need the following tools:
Hammer

1.2 Planning the Setup

IMORTANT INFORMATION!
read this chapter in order to be aware of all setup rules and instructions so you are able
to determine the best location for the Perimeter Switch and the perimeter wire layout.
1.2.1 Perimeter Switch Location
 Find a convenient spot outside the perimeter, but a location that is relatively easy for you to
access.
 The Perimeter Switch must be mounted vertically in order to maintain its' water resistance and
preferably in a dry and sheltered location.
 Close to a wall socket (230V/120V) – as it is connected to an indoor Power Supply.
Wires leading from the perimeter Wires leading from the perimeter
to the Perimeter Switch are to the Perimeter Switch are
adjacent and touching. adjacent and touching.
Zone A Zone A
1.2.2 Placing the Perimeter Switch
 The Perimeter Switch connector is designed for quick and easy
disconnection that allows you to easily move the perimeter switch
between plots.
 The Perimeter Switch also comes with a large stake that
fastens to its back, making transfer from one plot to
another easier by allowing you to disconnect the switch
and move it with the stake still attached (Figure 1.3).

Chapter 1 - Perimeter Wire Setup

Combination
Figure 1.1 – Tools required for the setup
Before starting the setup, it is necessary to first
The Perimeter Switch MUST be The Perimeter Switch MUST be
mounted vertically in order mounted vertically in order
to maintain its' water resistance to maintain its' water resistance
Figure 1.2
Perimeter Switch
Location
Small flat and
Pliers
Philips screwdrivers
Indoor Power Indoor Power
Supply Supply
10
Figure 1.3 - Perimeter
Switch with stake attached