Robomow RM200 Operating & Safety Manual page 32

Problem
Encountered
LCD display is in a - The language setting was changed or
foreign language. not correctly set.
- Important! It is possible to see the last 10 battery run times and the battery voltage at
the beginning of the operation in the 'Information' menu (refer to paragraph 2.3.2)
- Battery is not fully charged at the
beginning of the operation
- 'Work Time ' for that zone is set to
specific time and not to 'MAX'
Short run time,
operates less time
than normal
- Grass is extremely over grown or very
wet.
- Batteries are reaching a normal end of
life state.
- Confirm that the time in the mower is
set correctly (hour and date)
Robomow operates
- The 'GO' button was pressed with no
at the wrong times
meaning, by someone or by a pet
('Last stop cause' under the
'Information' menu should be 805).
- Wire disconnected from perimeter
switch or from the Base Station.
'Cut wire' indicator
flashing on
Perimeter Switch
or - Perimeter wire cut
the Base Station
beeps continuously
for 'Cut wire'
- Poor connections
Probable Cause/Event
32
Corrective/User Action
- Place the mower out of the Base Station
and follow the sequence listed;
- Press 'STOP' button few times to confirm it
is on the main display
- Press 'UP'  button twice
- Press 'GO' button once
- Press 'Down'  arrow button once
- Press 'GO' button once
- Press 'Down'  arrow button 4 times
- Press 'GO' button once
- Using the arrow, scroll to the correct
language
- Press 'GO' to confirm this selection
- Confirm the battery icon is fully and not
changed (while charging in the Base
Station) or 'Ready keep charging' message
is displayed (while charging through power
supply) prior the operation.
- 'Work time' can be changed under 'Zones
setup' menu
- Raise cutting height.
- Always mow the grass frequently enough to
prevent over growth.
CAUTION – Remove battery fuse before
-
lifting the mower
- Inspect blades for foreign material or debris
preventing rotation.
- Clean out accumulated grass clippings
using a wooden stick.
- Replace batteries.
- Set the time (See paragraph 2.2.3)
- To prevent unintended operation you can
activate the 'Child guard' or the 'Anti theft'
options, which requires pressing of few
buttons in order to start the operation.
- Confirm wire is plugged in and wire leads
are firmly attached.
- Walk along perimeter, including islands and
look for obvious cuts or breaks in the wire.
Repair with Robomow wire splice
connectors.
- Check and repair all loose/poor or corroded
connections.