Completing The Wire Fastening - Robomow RM200 Operating & Safety Manual

Follow the instructions, as shown in figure 1.25 to complete the test of the Perimeter Wire position:
Test the perimeter wire setup by choosing the ' Wire position' test (If required to find the 'Wire position'
menu refer to Figure 2.1). Robomow will follow the wire, while the mowing motor is switched off to prevent
any damage to the perimeter wire after the initial setup; Walk along the side of the Robomow while it is
following the edge until completing one loop of the perimeter without striking any object; If Robomow
collides in obstacle, it stops and drives back to allow you adjusting the wire position.
Press 'GO' to test Press 'GO' to test
wire position wire position
Walk along the side of the Walk along the side of the
Robomow while it is following Robomow while it is following
the edge until completing one the edge until completing one
lope of the perimeter without lope of the perimeter without
striking any object (it will stay striking any object (it will stay
in the Base Station). in the Base Station).

1.5 Completing the Wire Fastening

Once complete, walk back along the perimeter and add in wire pegs to those areas of the wire where it is
not pulled down below the level of the grass tips and close to ground level. Wherever the wire is raised or
loose, it should be tightened and pegged down with extra wire pegs (distance between pegs should be 0.5
to 1 meter in straight line and more when curved).
Wire position Wire position Wire position
Press GO to test Press GO to test Press GO to test
Wire position Wire position Wire position
Adjust the wire and press 'GO' to Adjust the wire and press 'GO' to
continue testing the wire position continue testing the wire position
Figure 1.25
Testing the Perimeter Wire position
19
Robomow collides Robomow collides
with obstacle, drives with obstacle, drives
back and stops back and stops
Adjust wire Adjust wire Adjust wire
then press GO then press GO then press GO