Chapter 1 - Base Station & Perimeter Wire Setup; Preparations; Planning The Setup - Robomow City 110 Operating & Safety Manual

Chapter 1 - Base Station & Perimeter Wire Setup

1.1 Preparations


Read carefully the Operating and Safety Manual prior to setup.

It is recommended to mow your lawn using a conventional lawn mower and water the ground
before starting the setup for easier driving of the pegs.

Confirm all parts for the setup are included (refer to 'What's in the Box' page 10).

During the setup you will also need the following tools:
Hammer

1.2 Planning the Setup

IMORTANT INFORMATION!
read this chapter in order to be aware of all setup rules and instructions so you are
able to determine the best location for the Base Station and the perimeter wire layout.
1.2.1 Base Station Location
 Set it in the biggest plot or zone;
 It should be placed along the outer edge (if setup on the lawn area) or outside the lawn (refer
to paragraph 1.3.2 for external setup of the Base Station);
 In the back yard, where it is not visible to the street;
 In a shady spot (better for a longer battery lifetime);
 On a relatively level ground;
 Close to a wall socket (230V / 120V) – the length of the low voltage cable is 15m (50ft)
(Note: the length of the low voltage cable must not be changed).
Distance between
wires greater
than 1m (3ft)
Figure 1.2 -
Base Station Location
Combination
Figure 1.1 – Tools required for the setup
Before starting the setup, it is necessary to first
Base Zone
Base Zone
11
Small flat and
Pliers
Philips screwdrivers
Base Station
location
Zone A
Wires leading to the next plot
are parallel and touching.
The gap between them
is for illustration only.