Safety - WeatherBug HD MotionCam Installation, Operation And Maintenance Manual

HD MotionCam Installation Manual

Safety!

Only qualified personnel should install the HD MotionCam.
While installation of the HD MotionCam is not particularly difficult, it does usually
require installation near the rooftop and working with electrical wiring, which presents
some amount of risk.
To limit risk to self and property, this manual should be thoroughly read and understood
before beginning installation. Adhere to all warnings on the unit and in the operating
instructions.
Installation must conform to national, state, and local building code requirements with the
most stringent guidelines being adhered to.
The HD MotionCam should only be installed by someone comfortable with being on a
high ladder or rooftop and who is authorized by the site to perform the installation. Roof
and ladder safety is crucial!
Allow only qualified Electricians to make electrical connections. Take all reasonable
safety precautions – double checking a power cable connection could save a life.
Stay as far away from other electrical wiring as possible. Never allow the camera
housing, the cabling, a drill bit, or any other item to contact electrical wires or
conduit. Injury or death could result.
A qualified installer will need to securely mount the unit to a supporting structure capable
of sustaining the weight of the unit (approximately 16 pounds) by using appropriate tools
and hardware. Failure to properly secure the HD MotionCam could result in the unit
separating from the support structure and falling. This would not only damage the
camera, but could injure anyone standing nearby.
If needed, WeatherBug may be able to recommend professional installers and an estimate
of the cost. If this is desired, please call WeatherBug Weather Station Technical Support
at 800-624-4205 or email support@aws.com.
Release 1, Version 1.0 -6- February 2011