Outdoor Installation - WeatherBug HD MotionCam Installation, Operation And Maintenance Manual

HD MotionCam Installation Manual

Outdoor Installation

For the following steps, the items listed below will be needed:
• Mounting Arm
• Install Sealant
• HD MotionCam in Housing
• Camera Support and Clamp
• Connector for Camera to Mounting Arm
• 3 Rubber Plugs
• Enclosure for Top of Camera Housing
• Cable Ties
• 5 mm Allen Wrench
1. Make sure the mounting arm will be mounted high enough so that the camera
pan/tilt/zoom features can be utilized. On the outside wall where the cables have
been pulled through and the camera is to be mounted, attach the mounting arm to
the wall and secure tightly (hardware not included). The mounting arm should go
over the hole created for the cables. The Power and Ethernet Cables should be fed
through the Mounting Arm for the camera connection to be
made. Once the Mounting Arm is secured to the wall, use the
Install Sealant around the outside of where the mounting arm
meets the wall to keep moisture from leaking behind the
mounting arm and down the cables.
2. Screw the threaded connector onto the mounting arm that will
also connect to the camera. Place the clamp with the
triangular attachment above the connector. Pictured to the
right.
3. Using the provided Allen Wrench, loosen the three screws
connecting the top of the camera housing to the camera itself. Once the screws
are loose, rotate the top of the housing CCW to separate the top from the bottom.
Release 1, Version 1.0 -18- February 2011