WeatherBug HD MotionCam Installation, Operation And Maintenance Manual page 19

HD MotionCam Installation Manual
4. With the top of the camera housing in hand, connect the Power and Ethernet
Cables from the Mounting Arm opening to the top of the camera.
5. Feed the attached cables into the mounting arm and line up the two screws with
the two openings on the connector. Push the top of the housing into the openings
and rotate the housing to the right to secure into place. Tighten the screws into the
threaded collar with a screwdriver for further security.
6. On the bottom portion of the housing, including the camera, take the wire
connected to the carabineer and attached the carabineer to the triangular piece on
the clamp attached to the mounting arm. This will support the weight of the
camera on the mounting arm while installation is finished and/or repairs are made.
7. Line up the connection points between the camera in the housing and the top of
the housing. Once the connection is made, rotate the bottom to the right to hold
the camera in place. Tighten the three screws with the provided Allen Wrench.
Release 1, Version 1.0 -19- February 2011