KitchenAid KUDD03DT Installation Instructions Manual page 7

6. Remove the house wiring knockout.
7. Run the house wiring through the conduit connector (not
supplied) and into the dishwasher through the knockout
opening.
8. Secure the conduit connector in the knockout opening.
9. From the house wiring, strip 1/2" (13 mm) of insulation off of
each wire.
10. Insert the black supply wire and the white neutral wire into
the appropriate wire clamp on the terminal block. Securely
tighten the clamps.
terminal block
black wire
terminal block
knockout
conduit
connector
1/2" (13 mm)
white wire
ground wire
WARNING
Electrical Shock Hazard
Connect ground wire to green ground screw.
Failure to do so can result in death or electrical shock.
11. Place the ground wire under the green ground screw. Use a
7 mm socket wrench to securely tighten the green ground
screw.
12. Tighten the conduit connector. Replace electrical cover.
13. Pull the bottom drawer runners all the way out. Make sure the
latches on the back of each drawer runner are facing forward.
drawer
runner
latch
bracket
14. If the bottom drawer was rotated, rotate the drawer to unwind
the hoses and then put the drawer on the runners, making
sure the hoses are looping upward.
15. Make sure both runner clips have snapped into place. If they
have not, pull the runner clips forward until they do.
16. Close the bottom drawer.
latch
7