KitchenAid KUDD03DT Installation Instructions Manual page 6

4. As the dishwasher is being pushed into the opening, slowly
pull the inlet hose, drain hoses and power supply cord
through the utility hole.
5. Remove the strap from upper drawer.
Go to "If Installing Flexible Trim Pieces" section.
Option 2: Direct Wiring Method
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
1. Place cardboard or other protective covering on the floor in
front of cabinet opening. Place the dishwasher on covering.
2. Disconnect power.
3. Open the bottom drawer.
4. Press in the right-hand runner clip and push it back about 6"
(15.2 cm). Repeat with the left-hand runner clip.
NOTE: When removing the drawer there is limited range of
movement due to the attached water hoses.
5. Lift the right edge of the drawer off its runner. Slide that runner
back into the dishwasher. Lift the drawer completely off the
left-hand runner.
6
6. Rotate drawer to the right onto its side and place on the
7. Slide the left-hand runner back into the dishwasher.
8. The electrical cover is located in the back left corner.
Remove factory-installed power cord.
1. Disconnect the black and white wires of the power cord from
2. Use a 7 mm socket wrench to remove the green ground
runner clip
3. Use a Phillips screwdriver to remove the strain relief screw.
4. Pull the power supply cord off the dishwasher through the
5. Close the strain relief and replace screw so it does not
protective cover.
electrical cover
Use a flat blade screwdriver to press the release button. Slide
the cover to the right and then pull up.
press
release button
the terminal block.
terminal block
screw. Remove the green ground wire.
Open the strain relief.
back of the dishwasher.
interfere with the electrical cover.
electrical cover
strain relief
green ground screw