KitchenAid KUDD03DT Installation Instructions Manual page 14

10. Lay the metal plate on the back of the custom front
panel.
11. Align the centerline marked on the custom panel with the
diamond shape and notch in the metal plate to center the
metal plate horizontally. Align the horizontal line with the
top of the metal plate.
centerline
12. Using the screws provided, fasten the metal plate to the front
panel through the 3 inner holes.
three
inner holes
13. Connect the medallion connector to the dishwasher
connector.
14. Slide the metal plate tabs into the notches and slots on
the dishwasher and gently pull up to lock in place.
14
horizontal line
top of plate
lower front
panel
end of medallion
connector
15. Line up the bracket holes with the pin holes and replace
each pin so that the pin line is vertical.
pin
16. Repeat steps 2–15 for other custom panel.
Option 2: Install custom toe panel
Custom toe panel dimensions
2-5/32"
(55 mm)
5" (12.7 cm)
max.
(varies)
The black prefinished toe panel can also have a custom front
panel with a thickness from 3/8" to 3/4" (9–19 mm) attached to it.
Determine the height of the toe panel custom panel: The
minimum height is 2-3/4" (70.5 mm). Measure from the top of the
adjacent cabinet door front to the floor. Subtract 28-15/32"
(72.3 cm) for needed toe panel height.
NOTES: Depending on countertop height, you may not have to
trim the toe panel.
Rugs placed in front of dishwasher could interfere with
toe panel. Clearance between floor and toe panel may
need to include the rug thickness.
1. Prepare the custom toe panel to specifications shown above.
2. Lay the custom toe panel face down.
3. Fasten the black plastic toe panel on the back of the custom
toe panel with the screws provided with the dishwasher.
plastic
toe panel
4. Partially open bottom drawer. Position custom toe panel
behind door and slide on the underside of tub.
5. Close the drawer and slide the toe panel back onto mounting
rails.
23-1/2" (59.7 cm)
17" (43.2 cm)
1/2" (12.7 mm) radius
custom
toe panel