Genee World Genee Vision 8100 User Manual page 23

BASIC PREPARATIONS
with a RS232 cable Please disconnect the computer from the RS232 port first. Then
1. Use one hand to hold the base of the visualiser, use the other hand to carefully lift
use buttons on the operation panel to control the projector.
up the camera stand of the unit.
The visualiser provides a 6-pin to 9-pin RS232 cable. If this cable does not match
to your projector's RS232 port, an additional RS232 cable is needed. This additional
RS232 cable can be made based on the pin location of the projector's RS232 con-
trol port. The pin locations of the visualiser are: the pin 1 is RXD (Received Data);
the pin 5 is TXD (Transmitted Data); the pin 4 is GND (Ground). Other pins are not
defined. The pin location information of the projector is provided by the projector's
manufacturer. The projector's RS232 control port normally has RXD pin, TXD pin
and GND pin, the name may be different. The parallelism of each data pin is shown
as follows:
Visualiser's RXD pin------------Projector's TXD pin
Visualiser's TXD pin------------Projector's RXD pin
Visualiser's GND pin------------Projector's GND pin
5. If you can not use buttons on the operation panel to control the projector,
2. Open the arm lights and rotate the camera head until they are in proper positions.
please use Code-Writing software's projector control code testing function to check
if the control code is correct.
Click "Projector" button, the following dialogue box appears as below:
3. Making connections:
Before making any connection, turn off all the power, including power of the visualiser
Connect the visualiser to a computer with a RS232 cable (Please
and the equipment to be connected.
Step 1: Connect power source.
First connect the power cord to the 12V IN connector.