Table of Contents
Advertisement
TITLE FUNCTION
OUT port to be displayed on the screen.
Step 5: Connect to the second video equipment with video input.
Press the "Title" button once and the image split into two parts, the upper 1/8
part of the image will freeze and stay on top 1/8 of the screen. Press "Title"
button again to exit the Title mode.
Note: This function is not available on S-Video and Video output.
Video out
IMAGE SAVE AND RECALL
Audio out
Press the "SAVE" button once to save one captured image, it can save up to 7
Video equipment
images. After 7 images are saved, the 8th image will replace the previous 1st
image and will become the new 1st saved image. (On the remote control)
Press the "RECALL" button once to display the saved images, then press the
numerical button to show the corresponding image. For example: Press "2" to
Projector Color monitor
display the second image. At this status, the function under each numeric key is
not available. Press "RECALL" again to exit this mode. (On the remote control)
INFRARED REMOTE CONTROL
Step 6: Connections for external control from the computer.
The remote control can control the camera from different angels. Please note
that an infrared remote control can only be used up to a certain distance from
the unit. Objects situated between the visualiser and the infrared remote control
and a weak battery may interfere with the reception.
On the left side of the visualiser stage, there is a built-in remote control storage
PROJECTOR MIC
compartment where you can store the remote control when not in use.
IMAGE SCROLLING
Press the " " button to scroll the image down to display the upper part of the
image. Press the " " button to scroll the image up to display the lower part of
the image.
Use the computer RS232 cable (9-pin to 9-pin) to make the connections shown
below to control the visualiser from an external computer. USB connection enables
capturing still images / video streams from the visualiser to the computer. Special
software is required for this operation.
4. Turn on the power by pressing the "POWER" button.
Video Cable
Video in
Side Panel
USB
RGB IN
USB cable
USB connector
of the computer
OUT
OUT
IN
AUDIO
VIDEO
S-VIDEO
VIDEO
AUDIO
AUDIO IN
RS232
RS-232 cable
RS 232 connector
of the computer
Rear Panel
IN
S-VIDEO
AUDIO
AUDIO IN
OUT
PROJECTOR
OUT-12V- IN
-COMPUTER-
IN
Hide quick links:
Advertisement
Table of Contents
