Adjusting The Monitor Channels - Behringer X32 Reference Manual

5.3 ADJUSTING THE MONITOR CHANNELS

(Reprinted from the TC Helicon FX150 Manual – see Manual for full details)
There are two knobs on the FX150:
1. The Edit knob controls parameters depending on selection.
The Edit knob has a semi-circle of LED's surrounding it. From left to right, these LED's represent
minimum to maximum values for each parameter. LED's may light one at a time or in groups,
depending on how many options are available.
2. The Master knob controls the overall monitor volume.
Each channel has several controls available, to adjust any of the parameters listed below, push the
button for the parameter that you'd like to change: Level, High, Mid, Low or Reverb (Monitor and
Vocals only – Input 1 and 2).
For example, press the "Level" button and use the Edit knob to control the volume of the associated
channel.
NOTE: If the Vocal Tone (Input 1 or 2) or Voice Cancel (Aux) button lights red at any time during your
performance, the Input is clipping and the level should be reduced.
Page 29