Behringer X32 Reference Manual page 20

Sound system training and reference manual
Hide thumbs Also See for X32:
Table of Contents

Advertisement

Then press the LIBRARY button beside the display and this will bring up pre-configured channel
settings that you can then load. If the person you are setting the channel up for has a saved
configuration, you will see it on the list – a master list of custom channels and their uses will be
maintained in the soundboard binder so please reference that as a guide.
Figure 23 - Selecting channel preset from LIBRARY
To load a channel configuration, simply use the LOAD PRESET knob to highlight the item on the list
and then press the LOAD PRESET knob to activate the configuration. You will be asked to confirm
using the right arrow button. If you load a channel that has been customized for an individual, then
the entire configuration and labelling has been loaded.
If no custom channel has been saved for an individual and you need to start from scratch, press the
SELECT button on the channel you want to configure and load the BLANK configuration – this
configuration has no customization or EQ and is a good starting point.
Once a blank channel has been loaded, you should customize the channel with a label (such as the
person's name), and optionally a color, and icon. To accomplish this, make sure the SELECT button
on the channel you wish to configure is highlighted, and press the SETUP button beside the screen.
You can then use the right arrow to move over to the SCRIBBLE STRIP tab and select the color, icon
and also enter a specific name. The name, color and icon are now viewable on the small LCD screen
associated with that channel
Page 18

Advertisement

Table of Contents
loading

Table of Contents