Piano (Optional Vocals) - Behringer X32 Reference Manual

2.1 PIANO (OPTIONAL VOCALS)

Place one of the FX150 monitors on the left side of the piano and run an XLR cable from one of the
monitor feeds under the back stage plate to INPUT 1 on the monitor. Now hook up the power
supply to the monitor, and plug it in to an outlet under the stage plate.
OPTIONAL VOCALS: If the piano player is going to use a vocal mic as well, then run an XLR cable from
the microphone, into the INPUT 2 on the FX150 and then run an additional XLR cable from the THRU
connection into an input channel under the stage plate – note the channel number and musician on
the worksheet.
Finally, run an XLR cable from the microphone inside the piano, to CH8 (labelled PIANO) under the
stage plate – note the channel number and label it piano on the worksheet.
Make sure the monitor is OFF, check the settings on the back panel and reset the monitor to defaults
– See Section 9.1.
The piano is now configured. See the section on using the FX150 monitor and remind the musician
how to use the monitor.
In this configuration:

INPUT 1 on the FX150 controls the monitor level

INPUT 2 on the FX150 controls the voice level (OPTIONAL)

The MASTER knob controls the overall level of the monitor
Figure 3 - Monitor Setup for Piano
Page 3