Programming Your Scanner - PSC DUET Programming Kit

Programming Your Scanner

To program your scanner:
1. Power up the scanner to be pro-
grammed by one of the following
methods:
• Connect the scanner's interface cable
at the scanner. Plug the AC/DC
Adapter into an electrical outlet of
the appropriate voltage and connect
its other end at either the port
located on the scanner's interface
cable connector (furthest from the
scanner) or its "pigtail" connection
(see Figure 1
• If the scanner is configured to
receive power off the terminal
(POT), connect the scanner via its
interface cable to a working host
terminal.
Wait for the scanner to complete the Selftest
routine and emit four tones. The green lamp will
light dimly, indicating that the scanner is in
normal Operating Mode.
2
* ).
Duet™ and VS800™ Scanner Programming Kit