Symbology Selection — continued
The programming bar codes for symbology
selection are contained on the following pages. Be
sure the symbology you wish to select is compat-
ible with your POS terminal before you change
these settings (see the "Symbologies Supported"
table in the Interface Selection section of this kit).
To change symbologies:
1. Place the scanner in Programming
Mode (see Programming Your Scanner
at the front of this manual).
2. Locate the programming bar code in
this section for the symbology you
wish to enable or disable (for example:
Code 39 — Enable) and scan the bar
code.
3. You may desire or need to select
certain options for the symbology
selected. Proceed to the options
section for that symbology (for
example: Code 39 Options) and
determine which (if any) option
settings should be modified.
R44-1740
173