Applied Engineering Vulcan IIGS User Manual page 7

FeQIu, ..
D power supplyFCC Ccrtifi(:d
D
ught-weight aluminum case
D F ..xtemally accessible fuse wilh spare.
D
110I22Q VAC, 50/60
Hz
Q
Buill-in Fan
Q
Cool Running
- 4O'C wlfan
- 6o'c
wlo fan under full load
Q
Power componcnts
10
case
Q 70 full
w-~tts
wlo fan
Q
Adju5table 5 Volts DC
Running Progrom$ from Vulcan
You do,, 't "eed to create a separate ptlrlllloPlfor
each program you U'tlPlt to run. The number of
programs each partition can hold is limilcd only by the
space you have allotted 10 lhe partition. Copy the
programs
to
the Vulcan partition just as you would copy
from one floppy disk to another.
If you have ix:en using the Finder or OIher program
Iluncher to run your programs, you can continue
to
U.'>C
II
to run programs from the Vulcan. (Refer \0 the manual,
"Apple
I1GS
System Disk User's Guide," that
was
included
wilh your
GS
for Findcr inStructions.)
Although you don1 n(.'(.'(\ separate partitions for each
program, If you're using GS/OS version 5.02, some
programs arc not compatible and will not run properly. If
you're having trouble running a non-copy protected
program from GS/OS, set up a separate partition with the
soI"tW;lre's operating system inslalled and boot from that
partition [0 run the software.
Copy
PrOlK''''
l'fOgroms
Copy protected programs are an except,on: some
programs arc written to run only from floppy disk and
cannOlix: run from
;I
hard disk.
VulCOt'l
HAPTER
NE
IIGS Installallon
In$fal/olion Procedure
You'll need no special tools to install the Vulcan. Simply
fonow the instructions ix:low.
0)
Nore: Iktrofit owners. the installation is oosically
the same when installing intO a lie Cllse. Follow the
same instructions.
1)
Tum Off and Ope,.. Computer
Tum off the computer and then press in the two latchc.>
at
the rear of Ihe case with your forefingers while using
your thumbs to push Ihe lid up and towards you. (See
picture following.)
Remove the IIGS cover
2)
lI.mo .... Power Supply
D R _ _
oIa4 .,..,. card.
If you have a card installed into slol I. you'll need to
remove it (0 give yourself room to reach the internal
power plug. Refer
to
your slot 1 card's manual for proper
removal.
Ch. , - IGS Installollon