Applied Engineering Vulcan IIGS User Manual page 20

.A::
Vulcan
H PTER
DOS 3.3, Pascal, and CP/ M
If you rarely use DOS 3.3, Pascal, or CP/M you'll
probably be bel1cr off running them from floppy and
using your Vulcan to run Prol>OS only. However,
if
you're a frequent user of DOS 3.3, Pascal, or CP/ M read
this chapter to quickly set up partitions for the different
systcrru;.
You mUSt be within a partition's opcr:uin8 system before
you can copy files
to
it. For example, you can't copy 10
the OOS 3.3 partitions while in ProDOS. Only the
panitions that are currently ON and conlain the system
currently booted will be recognized .
Usc this chapter to quickly set up partitions for DOS 3.3,
Pascal or CP/ M. Refer 10 Chapter 3 for specific
instructiOns and rulc.os about using the Partition Manager.
DOS J .J
DOS 3.3
The following is an abbreviated, step-by-step guide to
setting up a
OOS 3.3
partition. The Instruction..<; assume that
your Vulcan is either inst311l,o'd in or pseudo-sloucd to Slot
7 and thaI your S.2S" VulC3n Utility d isk
Is
In Slot 6, Drive
1.
If you have your
system (:onfigure<l differently, modify
the steps a(:oordingly.
1)
Boot the Vulcan and run the Partition Manager.
( Refer to the previous (:hapter for instructions.)
2) Choose "MODIFY" from the Partition Manager
menu.
3)
.5et up the number of partition(s) you want for
DOS
3.3
and lum the partitionCs} on. You can lurn
on up 10
Ju!Q
OOS
3.3
p3rtilions at a time.
4) fonnal the panition(s). 11le filSl volume must be a
l40K volume for the partition to
be bootab!e.
S) Quit the Partition Manager.
Ch. •. ProDOS
a. oos
3.3.
PcocaI.
end
CP(M