When You Use A Panasonic Proprietary Telephone - Panasonic KX-TD500 User Manual

2.1 Before Operating the Telephones

When You Use a Panasonic Proprietary Telephone

When you use a Panasonic Proprietary Telephone and the DSS Console, they may have some of the
useful function buttons listed below. These buttons make operations simple. The illustrations may
differ from the buttons on your telephone.
Used to answer an incoming call.
Used to receive an incoming intercom
call in the hands-free mode or mute the
AUTO ANS/
MUTE
microphone during a conversation.
Used for System Speed Dialling or
storing programme changes.
AUTO DIAL/
STORE
CO: Used to make or receive an
outside call. A Loop-CO button
supports all lines. Pressing this button
(CO)
seizes an idle line automatically.
(Button assignment is required.) Also
used as the desired function buttons.
(Button assignment is required.)
(Only the CO "number" (e.g. 1, 2) may
be shown on some telephones.)
Conference: Used to establish a three-
CONF party or five-party conference call.
DSS: Used to access the extension.
(Only the "S" may be shown on some
(DSS) telephones.)
Used to send a flash signal to the
Central Office or another connected
FLASH
PBX. Or used to disconnect the current
call and make another call without
hanging up.
Function: Located beside the display .
Used to perform the displayed function
or operation.
22
Call Forwarding / Do Not Disturb:
Used to perform Call Forwarding or Do
FWD/DND
Not Disturb.
Used to place a call on hold.
HOLD
Used to make or receive an intercom
INTERCOM
call.
Jog Dial: Used to adjust the volume
and the display contrast or select
desired items for each function.
Used to leave a message waiting
indication or call back the party who left
MESSAGE
the message waiting indication.
Used to shift the display to access
various features.
MODE
(KX-T7531 only)
Used for hands-free dialling. You can
monitor the party's voice hands-free.
MONITOR
Used to insert a pause during dialling.
Used as the PROGRAM button if it is
PAUSE
not equipped.
Operation