Start Wirelessn Discovery Tool - ProSoft Technology RadioLinx RLXIB-ICN User Manual

Start Here
User Manual
5 Set up the master radio first, using the R
RadioLinx Configuration Manager.
6 Click A
PPLY
To cancel the settings and start over, click the C
7 Unplug the Ethernet cable from the radio and plug it into the next radio to be
configured.
8 Set up a Repeater. Return to the WirelessN Discovery Tool. To be sure that
you are seeing the latest status of the radio(s), go to the toolbar (page 100)
and click the C
glass). Double-click the listing of the next radio to configure, and configure it
as a repeater radio.
9 Save the Radio Configuration. Save the repeater radio settings by clicking
A at the bottom of the Radio Settings screen. Repeat steps 7 through 9
PPLY
to configure each repeater in the network.
10 After configuring the network and its radios, physically label each radio.
Labeling eliminates confusion about which radios correspond with which
radio configurations in the software. You should identify the radio's name,
network SSID, and IP address, if set.
11 Install the radios and antennas.
The rest of this section describes each of these steps in more detail.

1.7.1 Start WirelessN Discovery Tool

1 Click the S
T
ECHNOLOGY
Page 18 of 129
to save the master radio settings.
icon (eraser) followed by the S
LEAR
button, and then navigate to P
TART
S window in the
ADIO ETTINGS
button.
LEAR
icon (magnifying
CAN
/ P
ROGRAMS RO
ProSoft Technology, Inc.
RLXIB-ICN ♦ 802.11n
Industrial Client
S
OFT
July 25, 2013