Table of Contents
Advertisement
Attempting to obtain power from the machine terminals may damage the ma-
chine circuit and/or the chemical injection system. Consult the chemical injec-
tion supply system instructions for operational details.
5.11.2 Chemical Signal Connections
Connection terminals are located in the rear control box for output signals to the chemicals injec-
tion supply pump. Refer to figure 5.8 on page 28.
Terminals SUPPLY 1 through SUPPLY 8 provide signals for external chemical supply pumps. The
signal is a maximum of 1 amp at 24V 50/60Hz.
Do not attempt to increase circuit breaker rating as this will cause damage to the washer-extractor
circuitry and void the warranty.
Any injection system pump, which requires 24-220V AC must be powered by a separate external
power source.
5.12 Optional Loading Chute Installation
Refer to figure 5.9 on page 29. NOTE: It is highly recommended that the bearing housings for
the chute be welded in place
Safely raise Chute above machine until the 4 mounting bolts are aligned and bolts can be
Figure 5.7: SI Series external chemical injection points
27
Hide quick links:
Advertisement
Table of Contents
