Dimensional Clearances; Machine Foundation - B&C Technologies SI Series Installation And Operation Manual

5.3 Dimensional Clearances

When installing the washer-extractor, it is important to allow adequate clearance on all sides of the
machine. When multiple machines are installed, it is important to allow for the specified minimum
clearances between machines. Figures 5.1 and 5.1 show recommended minimum clearances for
the various freestanding models.
Note: The dimensions are approximate and subject to normal manufacturing tolerances. If
exact dimensions are required for construction purposes, request certified drawings from the
factory. We reserve the right to make changes at any time without notice.
(A) Minimum rear clearance
(B) Minimum clearance between machine and wall
(C) Minimum clearance between machines
(D) Minimum front clearance

5.4 Machine Foundation

Thoroughness of details must be stressed with all foundation work to insure a stable unit installa-
tion, eliminating possibilities of excessive vibrations during extraction.
Figure 5.1: Minimum Service Clearances
Table 5.1: Minimum Service Clearnances
17
UNITS UNITS SI Series SI Series Tilt
Metric US
mm in 760
mm in 455
mm in 455
mm in 850
30 760 30
18 455 18
18 455 18
33 1220 48