Terminating The Sync Signal (Word Sync 75Ohm); Selecting Output; Output1); Showing The Accumulated Use Time (Time) - Sony DWR-S01D Operating Instructions Manual

Terminating the Sync
Signal
(WORD SYNC 75ohm)
This function provides termination for the
WORD SYNC connecter on the DWA-01D
digital wireless adapter.
ON: 75-ohm termination is added.
OFF: 75-ohm termination is not added.
Note
When the receiver is turned off, the
termination is released.

Selecting Output 1

OUTPUT1)

Selects the OUTPUT1 connecter of the
DWA-01D digital wireless adapter.
When the OUTPUT2 connector of the
adapter is being used for AES/EBU output,
the OUTPUT1 connector can be used for
sub-output.
RX1: Outputs the audio signal received on
tuner 1.
RX2: Outputs the audio signal received on
tuner 2.
RX1+2: Mixes and outputs the audio
signals received on tuners 1 and 2.
Showing the Accumulated
Use Time
(TIME)
You can display the accumulated battery
use time as a rough estimate of total
receiver usage.
The factory setting is "00:00".
Resetting the accumulated time
indication
1
Hold down the SET button until the
time indication flashes.
20 UTILITY Menu
2
Setting the Brightness of
the Display
Ten levels of brightness can be selected for
the organic light-emitting diode display.
The selectable settings are the following:
(Dark) 1 2 3 4 5 6 7 8 9 10 (Bright)
Automatic Dimming of the
Display
(ANALOG
The organic light-emitting diode display
can be set to dim or turn off after a certain
amount of time.
AUTO OFF: The display turns off after 30
seconds. The display goes on again when
you press the SET, +, or – button.
AUTO DIMMER: The display dims after
30 seconds. The display becomes bright
again when you press the SET, +, or –
button.
ALWAYS ON: The display stays on at the
brightness level set with the BRIGHTNESS
function.
Resetting Parameters to
their Factory Settings
(FACTORY PRESET)
All parameter settings can be returned to
their factory settings.
Holding down the SET button until a
message appears asking for confirmation.
Press the + or – button repeatedly to select
YES, and then press the SET button to
enter. The receiver parameters are reset to
their factory settings.
Press the – button so "00:00 RESET"
appears, and then press the SET
button.
(BRIGHTNESS)
(DIMMER MODE)