Sony DWR-S01D Operating Instructions Manual page 26

Notes
• When you set RF REMOTE to ON, the
transmitter will communicate with the
receiver to which it was previously
paired. To use the wireless remote
control function with another transmitter,
you must perform the pairing procedure
again for that transmitter.
• Pairing with multiple transmitters is not
possible.
The following transmitter settings
can be performed through wireless
remote control:
• Group/channel/band setting
• RF transmission power setting
• Audio input attenuation setting
• Low-cut filter setting
• Power save setting
• +48V setting
For details on the transmitter settings, see
"Changing the Settings on the Transmitter" on
page 27.
Cancelling the wireless
remote control function
In the TX1/2 menu, select RF REMOTE,
and then OFF.
Notes on the wireless remote
control function
The wireless remote control function on the
receiver uses the 2.4-GHz band and may
thus be subject to interference from other
devices.
• When pairing fails ("Pairing fail" is
displayed), carry out pairing again.
Successful communication between the
transmitter and the receiver has not
occurred within a given amount of time.
Pairing may be harder to do when another
receiver is engaged in pairing nearby.
• When it becomes hard to use the remote
control, the remote control may be
26 Using the Wireless Remote Control Function
improved by switching the wireless
remote control function off, then on again
in the RF REMOTE display, then re-
pairing with the transmitter (change to a
channel with less interference).