Figure 69 - Callback Center (Modem) Setup Screen - ADT A-SDR400LTE-80 User Manual

User's Manual
Highlight the box beside SMTP Server IP and enter the SMTP server IP address, obtained from
your system administrator.
Highlight the box beside E-mail recipient and enter the recipient's e-mail address. Use the virtual
keyboard to enter the e-mail address.
Highlight the box beside E-mail sender and enter the sender's e-mail address.
NOTE: The e-mail address must include the character "@" to be a valid address.
Callback Center Setup by Modem Connections
Figure 69 — Callback Center (Modem) Setup screen.
Highlight the box beside Pager Number and enter the telephone number of the pager. Enter the
number as it must be dialed from your telephone system; e.g., if you must dial "9" for an outside
line, enter "9" before the pager number.
Highlight the box beside Mailbox and enter the voice mailbox number if your pager uses a voice
mailbox.
Highlight the box beside Site ID and enter a three-digit site ID number.
When an event occurs, the DVR will dial the pager and leave a four-digit number. The first three
digits are the site ID number and the last digit is the type of event (1: Alarm In, 2: Text-In, 3:
Motion Detection, 4: Video Loss, 10: Recorder Bad, 11: Storage and 13: S.M.A.R.T.). For
example, "0754" means that Site 75 has lost video.
NOTE: The DVR will wait for at least four minutes between pages. If another event occurs
less than four minute after the DVR has notified a pager, it will not dial the pager. It does this
so that the telephone line will not be tied up.
You can save your changes by highlighting OK and pressing the button . Selecting Cancel exits
the screen without saving the changes.
54