Table of Contents
Advertisement
User's Manual
Configuring Recording Settings
NOTE: When the DVR is recording video, the REC LED on the front panel is lit and a red dot
appears on the monitor.
Your DVR offers a variety of flexible recording modes. You can set it up to record all the time or to
only record events. It can be set up to continue recording once the hard disk drive is full by
recording over the oldest video, or you can set it up to alert you when the hard disk is full and stop
recording.
Record Mode Setup Screen
Figure 43 — Record Mode Setup screen.
Highlight the box beside Resolution and press the
button. This toggles between Standard and
High.
Highlight the box beside End Of Disk and press the
button. This toggles between Overwrite
and Stop. When in the Overwrite mode, the DVR continues recording when the hard disk drive is
full by overwriting the oldest video. When in the Stop mode, the DVR stops recording when the
hard disk drive is full.
If the DVR is set to the Stop mode, you can set it to beep or activate the Alarm Out port when the
hard disk drive is full. Highlight the box beside On Disk Full Beep and press the
button to
toggle between On and Off. Highlight the box beside On Disk Full Alarm Out and press the
button to toggle between On and Off.
Pressing the
button on the front panel enters the Panic Recording mode. You can program
PANIC
the recording speed and quality when the DVR is in the Panic Recording mode. On Panic
Recording Speed can be set from 0.5 to 15 ips (12.5 ips PAL), and On Panic Recording Quality
can be selectable from High and Standard. Press the
button again to release the panic
PANIC
recording mode.
NOTE: When the DVR is in the Panic Recording mode, it ignores the time-lapse or event
recording settings and follows the panic recording settings.
32
- Quick Links:
- Connecting the Video Source
Hide quick links:
Advertisement
Table of Contents
