User's Manual
Connecting the Loop Through Video
Figure 4 — Video Loop Through connectors.
If you would like to connect your video source to another device, you can use the Loop BNC
connectors.
NOTE: The Loop BNC connectors are auto terminated. Do NOT connect a cable to the Loop
BNC unless it is connected to another terminated device because it will cause poor quality
video.
Connecting Audio
NOTE: It is the user's responsibility to determine if local laws and regulations permit
recording audio.
Figure 5 — Audio In and Out connectors.
Your DVR can record audio. Connect the audio source to Audio In. Connect Audio Out to your
amplifier.
NOTE: The audio input is from an amplified source. The DVR does not have amplified audio
output, so you will need a speaker with an amplifier.
Connecting the Monitor
Figure 6 — Video Out connectors.
Connect the SPOT monitor to either the Video Out or SVHS Out connector.
NOTE: If your monitor has an SVHS input, use it because it will give you better quality video
display.
NOTE: The Video Out (BNC) and the SVHS Out connectors may be connected to individual
monitors for simultaneous operation.
4