Table of Contents
Advertisement
DRIVE WHEEL RELEASE VALVES
Located on the right front corner of the
hydrostatic pumps.
Drive wheel release valves are used to release
the hydrostatic drive system to allow the
machine to be moved by hand without the
engine running.
With a 5/8 wrench, turn both valves one turn
counterclockwise to release the drive system.
Turn clockwise to reset the drive system. Do
Not overtighten. Do Not tow machine.
BLADE ENGAGEMENT SWITCH
Located on console
Switch must be pulled out (up) to engage the
blades. Switch is pushed in to disengage the
blades.
PRE-START
Fill fuel tank on level ground. For best results
use only clean, fresh regular grade unleaded
gasoline with an octane rating of 87 or higher.
IMPORTANT: Never use methanol, gasoline
containing methanol, gasohol containing
more than 10% ethanol, premium gasoline,
or white gas because the fuel system could
be damaged.
Do Not add oil to gasoline
Do Not over fill fuel tank. Fill the fuel tank to
the bottom of the filler neck. The empty space
in the tank allows gasoline to expand.
Overfilling may result in fuel leakage or damage
to the engine or emission system.
Make sure you understand the controls, their
locations, their functions, and their safety
requirements.
Refer to the Maintenance section and perform
all the necessary inspection and maintenance
steps.
16
Hide quick links:
Advertisement
Table of Contents
