Maxplus Industries HTS 9300 User Manual page 9

6.1 Getting Started
<Figure 6-4>
Manual Scan <Figure 6-6>
Select transponder which you want to scan.
If you want to change an information of current transponder ( Frequency, Symbol Rate
and Polarization ) , just input information using NUMERIC button.
If you want to add new transponder, press GREEN button.
If you want to delete current transponder, move cursor to the Frequency and press
YELLOW button.
PID Scan <Figure 6-7>
Select transponder which you want to scan.
If you want to change an information of current transponder(Frequency, Symbol Rate
and Polarization), just input information using NUMERIC button.
If you want to add new transponder, press GREEN button.
If you want to delete current transponder, move cursor to the Frequency and press
YELLOW button.
You can also search a channel of the specified transponder by specifying PID
data(Video, Audio and PCR).
<Figure 6-5>
14
6.1 Getting Started
<Figure 6-6>
Note : Now you have complete all steps needed for watching programs.
If you could not see the program after finishing these procedures, please
contact a shop where you bought your receiver or installer who installed
your receiver.
4) Select Channel
You can change the current channel to any other channel you want.
In case you want to select a channel at random without knowing the channel name,
you can navigate between channels untill you fild the channel you want.
If you know the channel number, enter the number and wait 2 seconds till the channel
changed.
If you know the channel name, press
<Figure 6-8>
<Figure 6-7>
and the channel list will appear.<figure 6-8>
15