Advertisement
Adjusting the d:fine
4065
TM
4065 is pre-formed but may require adjustment in order to get a tight, fixed position to the back of
the neck. Adjust the steel tube carefully at the curves.
A protection grid is mounted over the microphone head. If clogged with dirt or make-up,
gently remove it and clean it with distilled water.
Adjusting the d:fine
TM
4066, 4067, and 4088
The size of the headset mount can easily be adjusted. Change the standard bend by carefully expand-
ing the distance between the earhooks.
To change sides, simply click the boom out of the clips and switch it over to the other side.
The remaining two clips are not used. The soft cable must not be attached into the clips.
Adjusting the d:fine
TM
Omnidirectional, d:fine
TM
Directional, d:fine
The directional characteristics of the microphone is indicated on the flat microphone
head with
for omnidirectional and
for directional as shown on page 3. This marking
should always point towards the mouth. Mount a directional headset 2 – 3 cm (1 in) from the
corner of the mouth to ensure optimal sound quality.
For the single-ear, just open the spring hook lightly, first place the slide behind your ear-
lobe (Pic. 1) and let go of the spring over your ear (Pic. 2). For the dual-ear, place the
headset behind your ears and place the springs like for the single-ear. Adjust the headset
mount by pulling or pushing the wires until it fits tight (Pic. 3).
Pic. 1
Pic. 2
Correct placement behind the earlobe
TM
66 and d:fine
TM
88.
1. When using the dual-ear mount,
the supplied cable relief should be applied.
Pic. 3
2. Slide the cable into the relief cut.
See instruction video at
3. The relief is pre-mounted with dual-ear headsets
and supplied with single-ear.
dpamicrophones.com/dfine
Advertisement
