Advertisement
Quick Links
Advertisement
Related Manuals for DPA 6066
Summary of Contents for DPA 6066
- Page 1 6066 Subminiature Headset...
- Page 2 6066 Subminiature Headset is IP58 certified. This durability is achieved through a number of defense mechanisms. Water-repellant nano- coating of the cover and housing, hermetic sealing of the sensitive amplifier at the core of the microphone, and dual gold plating of the...
- Page 3 Adjusting frame size Adjusting boom length The frame is one size fits all with a Moving the guides towards each other Release the sliding lock by gently pulling Gently pull (to shorten) or push (to Move the sliding lock back on the ear simple adjustment mechanism for quick will enlarge the frame and moving it away from the ear grip.
- Page 4 Adjusting boom height Adjusting ear grips The boom pole can be pivoted up and While holding the frame in one hand, This headset relies on a 3-point ear To adjust the ear grips further, press and down at a fixed point below the ear gently move the boom pole up or down gripping system –...
- Page 5 Flip boom (left to right side) Flip boom Detach the boom pole from the ear (starting at the back and tipping Move the cable to the other side of the Move the boom pole to the other Release the sliding lock and turn the oval and can only be locked in two posi- grip by gently pulling the boom down forward).
- Page 6 90º Cable management system Disconnecting the service connector For service purposes only! The cable guide can be used to move The cable guide can be moved from left – just make sure the cable isn’t pulled For service purposes (replacing boom First remove the protective cover and –...
-
Page 7: Specifications
Placement of microphone Specifications Directional pattern Sensitivity, nominal ±3 dB at 1 kHz Max. SPL, peak before clipping Omnidirectional 6 mV/Pa; -44 dB re. 1 V/Pa 144 dB Cartridge type Equivalent noise level, A-weighted Connector DUA9531-B Pre-polarized condenser Typ. 26 dB(A) re. 20 µPa MicroDot, TA4F, LEMO and MiniJack Frequency range Total harmonic distortion (THD) -
Page 8: General Maintenance
General maintenance The cable is usually longer than required. Make sure that excessive cable is wound up in soft figure-of-eight loops (preferably 6-8 cm (2.5-3 in) diameter) and avoid kinks in the cable. Use organic oil (e.g. olive oil) or lukewarm distilled water to remove residue from tape, glue or makeup on the cable. -
Page 9: Warranty
If you are not satisfied with the characteristics exhibited by This product conforms to all relevant directives approved by limited warranty. this product, please contact your nearest DPA Microphones the European Commission. representative for support. Product features and specifications are subject to change without notice.
Need help?
Do you have a question about the 6066 and is the answer not in the manual?
Questions and answers