NEC M100 Installation Manual page 22

Caution
・ When removing the power plug from the electrical outlet, always grasp the plug. Do not pull the power cord.
Pulling the power cord may expose or disconnect the core wires and cause a fire or electric shock to occur.
・ Do not place any object on the disk array unit. Also, do not drop any object onto the disk array unit or crash
any object into it.
Failure to follow these prohibitions may cause the disk array unit to become unbalanced and tip over or fall.
It may also cause the disk array unit to fail or malfunction.
Caution
・ Select an installation location for the disk array unit that satisfies the product specifications as well as the
following conditions. Otherwise, the unit may be damaged, data may be lost, or the life of the unit may be
shortened.
- Do not place the disk array unit in a location that is high in humidity, dust, or oily smoke, a poorly ventilated
location, or any location with fire.
- Do not use the disk array unit in an area subject to salt-air damage.
- Do not use the disk array unit in a bathroom, shower room, or any other room where water is used.
- Install the disk array unit in a location that is not exposed to direct sunlight.
- Install the disk array unit in a location with little dust and low humidity.
- Install the disk array unit in a flat, stable location where severe vibrations do not occur. A location subject to
severe vibrations or an unstable location such as an inclined surface may cause the unit to fall or tip over.
- Do not install the disk array unit near a passageway. If it is installed near a passageway, the disk array unit
may fail or malfunction due to vibrations caused by people walking by.
- Do not install the disk array unit in a location where power cords or various types of cables are found.
- Do not block the air vents of the disk array unit. Air is taken in from the front of the unit and is exhausted
from the rear. Do not seal off the front or rear of the disk array unit with a cover or lean any objects against
them.
- Do not install the disk array unit near any device that generates electrical noise including any device using
a motor such as an ungrounded air conditioner or washing machine.
- Do not install the disk array unit in the vicinity of a device that generates a strong magnetic field (such as a
motor or speaker).
・ Insert the power plug snugly all the way into the power outlet. Failure to do this may cause a fire to occur or
the unit to fail.
Prohibited
Instruction
- 21-