Arctic Cat Crossfire 600 Operator's Manual page 32

Mountain/crossover models
Table of Contents

Advertisement

2. If the brake fluid is not visible in the
sight glass, remove the reservoir cover
and add Arctic Cat approved brake
fluid until the fluid is at the recom-
mended level. Install and secure the
reservoir cover. Do not allow moisture
to contaminate the brake system.
CAUTION
Brake fluid is highly corrosive. Do
not spill brake fluid on any surface
of the snowmobile.
! WARNING
Do not overfill the brake fluid reser-
voir. Overfilling the reservoir may
cause the brake system to hydrauli-
cally lock. Use only Arctic Cat
approved brake fluid. Never substi-
tute or mix different types or grades
of brake fluid. Brake loss can result.
Brake loss can result in severe injury
or even death.
Changing Brake Fluid
The brake fluid must be changed on a reg-
ular basis and whenever the brake fluid
has been overheated or contaminated. The
brake fluid should be changed every 1000
miles or at the end of the snowmobiling
season, whichever occurs first. Take the
snowmobile to an authorized Arctic Cat
Snowmobile dealer for this service. This
service is at the discretion and expense of
the snowmobile owner.
Checking Brake Lever
Travel
Before each use, check the brake lever
travel using the following procedure:
1. Compress the brake lever fully.
NOTE: Do not pump the brake
lever as it will produce an inaccurate
reading.
28
2. Measure the distance between the
brake lever and the handlebar. The
distance must be greater than 2.54
cm (1 in.).
741-328A
3. If the resultant distance is less than
specified, take the snowmobile to an
authorized Arctic Cat Snowmobile
dealer for service. If not under war-
ranty, this service is at the discretion
and expense of the snowmobile owner.
! WARNING
Do not operate the snowmobile if the
compressed distance between the
brake lever and the handlebar is less
than 2.54 cm (1 in.). Brake loss may
occur. Brake loss can result in
severe personal injury.
Bleeding Brake System
If the brake lever feels spongy when
applied, the brake system may need to be
bled. To bleed the brake, use the follow-
ing procedure:
NOTE: The brake system may be
bled by the snowmobile owner if
qualified to do so. If the owner does
not feel qualified, take the snowmo-
bile to an authorized Arctic Cat
Snowmobile dealer for this service.
This service is at the discretion and
expense of the snowmobile owner.
1. Remove the reservoir cover and fill
the
reservoir
approved brake fluid.
CAUTION
Brake fluid is highly corrosive. Do
not spill brake fluid on any surface
of the snowmobile.
741-328B
with
Arctic
Cat

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents