Edge Products CS User Manual page 29

U S E R
Figure 13
3. Choose "Odometer" to set
your current Odometer reading.
The screen shown in Figure 14
will appear.
Figure 14
4. Use the Arrow buttons to
adjust the values up or down.
5. Press the Enter button to
move to the next Digit.
6. Once all digits have been en-
tered, the Maintenance Manager
screen will reappear showing
your entered value.
(See example in Figure 13.
A value of 49,170 was entered).
7. Once the Odometer is en-
tered and displayed, chose the
"Maintenance Items" option.
G U I D E
O P E R A T I N G I N S T R U C T I O N S
Alert Status Box
Figure 15
Other Maintenance Items not
listed in Figure 15 may include:
-Change Spark Plugs
-Change Trans Fluid
-Chk Trans Case Fld Lvl
-Inspect Brake Pads
-Lube Front Drive Shaft
-Lube Tie Rod Ends
-Rotate Tires
8. Chose the item you would
like to maintain. (For demon-
stration purposes we will chose
"Change Engine Oil". The
following steps may also be ap-
plied to all other items).
NOTE: Refer to Figure 15.
Once a Maintenance Item is
turned on, the Alert Status Box
to the left of the item will light
up. If it is green, the item is
not yet due for service. If it is
yellow, the item is about to be
due and within the specifi ed
Alert Threshold. If it is red,
the item is due for service. If it
remains black, the item is not
29