Show Alerts - Edge Products CS User Manual

O P E R A T I N G I N S T R U C T I O N S
active within the main menu.
1. Selecting "View Camera" in
the "Main Menu" list, will
allow you to view the camera
image. If you would like to
stop viewing the camera image,
touch the screen and the main
gauge screen will re-appear.
WARNING: Do not rely
solely on the camera image for
backing up. It is possible for
the camera image to freeze.
Always use your mirrors, and
look behind you before backing
up. Objects in the view may be
closer than they appear. If you
are using a camera not manufac-
tured by Edge Products, the
image may be reversed.

SHOW ALERTS

The CS/CTS device is equipped
with an alert system that notifi es
the user when vehicle param-
eters are outside a user-defi ned
value. There are a few ways the
CS/CTS alerts are indicated and
accessed:
MAIN SCREEN METHOD
If one of your gauges on the main
screen (Refer to Figures 1 & 2)
contains the alert parameters, 2
things will occur:
1. The alert notifi cation will sound
only if it is turned on. (Sound will
turn off after a few seconds
20
U S E R
depending on the sound duration
you have set)
2. The gauge back-light will fl ash.
(Will continue fl ashing as long as
the parameter is outside the
user-defi ned value)
NOTE: The alert sound and
fl ashing will discontinue once
parameter is no longer out of the
user-defi ned value.
ALERTS SCREEN METHOD
This Alerts screen (Figure 6)
will show all parameters for
which an alert has been set. If
an alert value is outside the
user-defi ned setting, it will fl ash
red. The Alerts screen will stay
in view for a minimum of three
seconds, until no alert condition
exists, or until the screen/menu
button is touched, at which
point it will return to the main
gauge screen.
Figure 6
NOTE: This menu only ap-
pears when there is an alert
active. It shows the current,
active alerts and their current
values.
G U I D E