Dryer Stacking Instructions; Kit Components; Preparing Dryer For Stacking - Electrolux IQ-Touch Wave-Touch EIFLW55H Technical & Service Manual

Installation Information

Dryer Stacking Instructions

Kit Components: (See Figure 2-40)
A 1 Dryer Stacking Instructions.
B. 1 Front bracket with adhesive strip.
IMPORTANT - DO NOT remove RED
backing from adhesive strip until instructed to
do so.
C. 2 rear brackets.
D. 2 strips of self-adhesive protective film.
E. (6) #10 (16 x 3.75) screws.
Preparing to Stack
1. Be sure there is adequate space to stack dryer
on top of washer.
2. You will need a screw driver with a #2 square
bit, isopropyl alcohol and a clean cloth.
3. Read washer and dryer installation instructions
packed with each appliance prior to stacking.
4. Be sure washer and dryer are both unplugged.

Preparing Dryer for Stacking

1. If already installed, disconnect dryer from
electrical and gas connections and exhaust
venting. On models with Steam Option,
disconnect water supply to dryer.
2. Protect floor with cardboard or other covering
and carefully tip dryer onto its back.
(See Figure 2-41)
3. Remove adjustable leveling legs and save for
future use.
4. Attach front stacking bracket to dryer front
with (2) - #10 screws. (See Figure 2-42)
IMPORTANT
DO NOT REMOVE RED BACKING FROM
ADHESIVE STRIP YET!
DO NOT REMOVE ANY EXISTING SCREWS
FROM FRONT PANEL!
5. Carefully return dryer to upright position.
A
B
C
D
Figure 2-40.
Figure 2-41.
Figure 2-42.
2-20