Electrolux IQ-Touch Wave-Touch EIFLW55H Technical & Service Manual page 10

B B a a s s i i c c I I n n f f o o r r m m a a t t i i o o n n
A A u u t t o o m m a a t t i i c c T T e e m m p p e e r r a a t t u u r r e e C C o o n n t t r r o o l l ( ( A A T T C C ) ) S S y y s s t t e e m m
This method of temperature control uses a thermistor input from the drum water Negative Temperature
Coefficient Thermistor to sense the water temperature in the drum. It also controls the amount of hot
water used for a given fill and temperature selection.
The following are the temperature ranges for the wash/rinse cycles:
Temperature Setting Temperature Range
Sanitize 67°C (152°F) +/- 5°C
Hot 55°C (131°F) +/- 5°C
Eco Hot 45°C (113°F) +/- 5°C
Warm 29°C (84°F) +/- 4°C
Eco Warm 27°C (81°F) +/- 3°C
Warm Rinse 24°C (75°F) +/- 3°C
Cold 15°C (59°F) +/- 5°C
W W a a t t e e r r L L e e v v e e l l
The spinner tub vanes must not be in water during this check.
Check is taken at the back and center of the washgroup.
Water Pressure must be between 20 and 120 P.S.I.
I I n n s s t t a a l l l l a a t t i i o o n n C C y y c c l l e e
This cycle checks the basic functionality of the unit. It also verifies that the water hoses have been
hooked up properly, hot to hot and cold to cold. To verify that the hoses have been hooked up properly,
the unit turns on the hot water valve until the water reaches 130 mm (5.11 inches) in height. The
temperature in the drum has to increase from ambient to a specified value for the algorithm to recognize
the water lines have been properly hooked up. If the temperature doesn't increase to the specified value
either within the 130 mm fill level or a given amount of time, the "CHECK HOSES" warning will be
displayed, the machine will drop out of the install cycle and drain what water has accumulated. When this
happens verify that the hoses were properly connected and if they have been, then push the Cancel
button (clears the message) and the unit is ready for use.
If water remains in the unit after following the procedure above, move the cycle knob to the Drain Spin
Cycle and drain the rest of the water from the tub. When the drum starts moving, the water has been
completely drained and the cycle can then be cancelled.
1-8
Water Height In
Drum
1.75 +/- 0.5 In.
4.45 +/-1.27cm
A A l l l l M M o o d d e e l l s s