Table of Contents
Advertisement
6.
ASSEMBLY
S
DANGER
While installing the antenna, wear the appropriate
safety equipment for the job to be carried out.
Operations to be carried out outside the boat.
1. First of all, make sure you have chosen a
correct position to install the antenna (see
section 5: "Installation").
2. Remove the antenna from the packaging box.
3. Carefully clean the 4 mounting plates (P) on the
antenna and the area in which the antenna will
be located with alcohol and let evaporate
before applying the sealant (Fig. 7).
4. Apply some sealant like SIKAFLEX®252 on the
plates (Fig. 8).
5. Place the antenna in the appropriate position
and apply a good pressure on the radome sides
to make the plates correctly adhere to the
mounting surface.
Wait for the silicone to solidify (time varies
according to outer temperature).
6. OPTIONAL OPERATION: remove the plates by
unscrewing the 2 nuts securing them to the
lower radome. Drill the lower radome with an
8 mm bit near the punching, put back the plates
and drill near the previously made holes, again
using an 8 mm (Fig. 9) bit.
P
P
Fig. 7
www.glomex.it
P
P
Fig. 8
Fig. 9
S
WARNING
Fastening with sealant is necessary and sufficient
for the correct use of the equipment.
Fastening with the screws (not included) is
optional.
Fastening with screws only does not guarantee
a perfect coupling of the radome to the boat.
GLOMEX declines any liability for an incorrect
coupling of the radome to the boat.
47
DANUBE 2 R500
Advertisement
Table of Contents
