Optional Accessories (Not Included) To Use Glomex Antennas; Necessary Tools For Assembly (Not Provided) - Glomex RHEA V8100S2 User And Installation Manual

3.1 OPTIONAL ACCESSORIES (NOT INCLUDED) TO USE GLOMEX ANTENNAS

To be able to use your new GLOMEX satellite
antenna for boats, you will have to procure or buy
also:
- a TV set;
Optional accessory
SD card with new satellite
SD card with software update
Stainless steel support 0°- 5°
Twin radome
4. NECESSARY TOOLS FOR
ASSEMBLY (NOT PROVIDED)
Procure all tools and materials listed below. They
will be necessary to complete installation.
- Electric drill (1).
- 8.5 mm drill tip for radome assembly (2).
- 28 mm hollow mill for drilling the passage hole
for the antenna connector cable (3).
- Phillips screwdriver (with adequate dimensions
for control unit installation) (4).
- 11 mm wrench (for the installation of the coaxial
cable connectors) (5).
- Reciprocating saw (to create the compartment
in case of wall built-in installation of the control
unit; use the template provided on page 51) (6).
S
WARNING
Plan the whole installation before proceeding!
Please consider the lay-out of the various compo-
nents, the distance between them, the length of the
various cables and the accessibility to the equip-
ment once it is installed.
www.glomex.it
- a satellite receiver for channel selection.
The table below lists all the GLOMEX optional
components, with relevant code.
GLOMEX code
4.120.0077
4.120.0078
V9500
V8100S2TWIN
S
WARNING
Always lift the antenna from the lower radome and
never from the upper radome or any part inside it.
Fig. 2
43
RHEA V8100S2
Upper radome
Lower radome