Table of Contents
Advertisement
DANUBE 2 R500
7. The equipment does not find
the satellite (the led on the
control unit flashes alternately
red and orange)
8. Disturbed images
9. Confused,
incomplete
obstructed images
10. The decoder blocks
11. The equipment operates with
still boat but not with moving
boat
For further information, please address to the
GLOMEX Service Centre (see section "Technical
Support").
11. RESHIPPING
Should you need to return the antenna to
GLOMEX, place it in a box, possibly the original
one, making sure it is well packaged and that the
upper and lower side are well recognizable.
In order to prevent any damage to the antenna
during transport, it is necessary to send it inside the
original radome (upper and lower).
Together with the antenna, please also send the
control unit, so that a verification of the whole
system is possible.
NOTE: GLOMEX will not be liable for possible
damage occurred during transport due to incorrect
packaging.
- the
satellite
obstructed by trees, buildings,
overpasses, mountains
- the equipment software is not
up to date
- wrong SKEW adjustment
- bad weather conditions
- failure of the receiver
and
- condensate or rain on the
radome, which can disturb the
signal with still vehicle
- bad weather conditions
- alternating current fluctuations - refer to the user manual of the
- the
satellite
obstructed
- failure
in
the
system
66
signals
are
- move the boat to allow an
unobstructed
antenna
- please contact the Service
Centre to ask for the software
update by SD card
- adjust the SKEW by following
the instructions on page 52
- refer to the user manual of the
receiver for support, spare
parts and warranty conditions.
- remove
deposits from the radome with
a fresh water jet (not under
pressure)
- periodically
detergent suitable for dishes
(no alcohol-based detergent)
to the radome surface and let
dry up
receiver for support
signal
is
- move
obstacles
satellite signal
gyroscope
- contact the Service Centre
S
WARNING
Do not ship the antenna to GLOMEX for repairs
without
having
received
authorization to return the material (RMA), as
reported
in
the
conditions.
NOTE: to remove the antenna from the boat, just
remove the upper radome by unscrewing the 8
screws near the base, unscrew the 2 screws on
each fastening foot and lift the antenna from the
lower radome.
The feet remain glued to the boat for a subsequent
new installation. After its removal from the boat,
fasten the upper radome onto the lower one again
using the 8 screws previously removed.
view
for
the
condensate
apply
a
liquid
away
from
possible
obstructing
a
corresponding
general
warranty/support
www.glomex.it
the
the
Advertisement
Table of Contents
