FEC -150 User Manual page 28

ESC % n
[Name] To select/cancel user defined character set
[Type] ASCII
HEX
DECIMAL 27
[Range] 0 ≤ n ≤ 255
[Description] To select/cancel user-defined character set.
User-defined character set is cancelled when LBS of n is 0,
User-defined character set is selected when LBS of n is 1.
ESC & y c1 c2 [x1 d1... d(y X x1)]...[xk d1...d(y X xk)]
[Name] To define user-defined characters
[Type] ASCII
HEX
DECIMAL 27
[Range] y = 3
32 ≤ c1 ≤ c2 ≤ 126
0 ≤ x ≤ 12 (Font A (12×24))
0 ≤ d1... d(y × xk) ≤ 255
[Description] To define user defined characters.
y defines the number of bytes in the vertical direction.
c1 defines the code of beginning character, and c2 defines the end code.
x defines number of dots in horizontal direction.
ESC * m nL nH d1... dk
[Name] To set bit image mode
[Type] ASCII
HEX
DECIMAL 27
[Range] m = 0, 1, 32, 33
0 ≤ nL ≤ 255 , 0 ≤ nH ≤ 3 , 0 ≤ d ≤ 255
[Description] Use m to select the bit image, where number of dots is defined by nL and
nH as shown below.
m Mode
0 8-dot single-density
1 8-dot double-density
32 24-dot single-density
33 24-dot double-density
Rev. 1.00
ESC % n
1B 25 n
37 n
ESC & y c1 c2 [x1 d1... d(y X x1)]...[xk d1...d(y X xk)]
1B 26 y c1 c2 [x1 d1... d(y X x1)]...[xk d1...d(y X xk)]
38 y c1 c2 [x1 d1... d(y X x1)]...[xk d1...d(y X xk)]
ESC * m
1B 2A m
42 m
Vertical Direction
Number
of dots
8
8
24
24
nL nH d1... dk
nL nH d1... dk
nL nH d1... dk
Horizontal Direction (*1)
Density Density
67 DPI 100 DPI
67 DPI 200 DPI
200 DPI 100 DPI
200 DPI 200 DPI
- 28 -
FEC-150
Number of Data (k)
nL + nH × 256
nL + nH × 256
(nL + nH ( 256)(3)
(nL + nH ( 256)(3)