Dip Switch Setting - FEC -150 User Manual

FEC-150

3. DIP Switch Setting

※ Note
It is required to turn off the printer when setting the DIP switch to prevent electrical
rejection and damage to the printer.
Replacement of the contact device or the printing density can be set on the DIP switch.
1. Make sure the printer powers off.
2. Release the tray by removing 3 screws. The PCB on the tray is exposed.
3. Note that when the switch turns to "ON", use the tweezer or sharp tool to unscrew the
switch.
- 14 -
Rev. 1.00