Setting The Dip Switches; Setting The Dip Switch (Rs-232C Serial Interface); Setting The Dip Switch (Ieee1284 Parallel, Usb2.0 Interface); Setting The Memory Switches - FEC -150 User Manual

Refer to the following settings of the DIP switch.

3-1 Setting the DIP Switches

3-1-1 Setting the DIP switch (RS-232C Serial Interface)

• DIP Switch
SW Function
1-1 Auto Cutter
1-2
1-3
Baud Rate
1-4
• Table 1 – Baud rate (bps) Selection
Transmission Speed
9600
19200
38400
115200

3-1-2 Setting the DIP switch (IEEE1284 Parallel, USB2.0 Interface)

• DIP Switch
SW Function
1-1 Auto Cutter
1-2
1-3
1-4

3-2 Setting the Memory Switches

This printer has "Memory Switch" set which is software switches. Memory Switch set has
"MSW1", "MSW2", "MSW8", "MSW9" "Customize value", "Serial communication condition".
"Memory Switch setting utility" can change the Memory Switch set to ON or OFF as shown
in the table below. (default : all OFF)
※ NOTE
- The Memory Switch is available to be changed by three methods.
- Memory Switch setting utility.
- Control from BXL/POS command.
Settings of the Memory Switch are stored in the NV memory : therefore, even if the printer
is turned off, the settings are maintained.
Rev. 1.00
ON
Disable
Reserved
Refer to Table 1
1-3 1-4
OFF OFF
OFF ON
ON OFF
ON ON
ON
Disable
Reserved
- 15 -
FEC-150
OFF Default
Enable OFF
-
OFF
OFF
Default
9600
OFF Default
Enable OFF
-
-
-