KitchenAid 8302472A Installation Instructions Manual page 6

WARNING
Tip Over Hazard
A child or adult can tip the range and
be killed.
Connect anti-tip bracket to rear
range foot.
Reconnect the anti-tip bracket, if the
range is moved.
Failure to follow these instructions can
result in death or serious burns to
children and adults.
line
anti-tip
bracket
6.
Position top of anti-tip bracket at
line marked in step 5 and mark holes.
Drill two 1/8" (3 mm) holes. Use screws
provided to fasten anti-tip bracket to wall.
NOTE: Anti-tip bracket must be mounted
securely to stud in wall behind the range.
Depending on thickness of the wall
covering, longer screws may be required.
7.
Make electrical connection.
If your house has aluminum wiring, see
"Electrical requirements" page 5.
6
Disconnect power before servicing.
Use 8 gauge copper wire.
Electrically ground range.
Failure to follow these instructions can
result in death, fire, or electrical shock.
This range must be connected to a
grounded, metallic permanent wiring
system or a ground connector should be
connected to the ground terminal or wire
lead on the range.
This range is manufactured with a frame-
connected, bare or green ground wire.
wall stud
Connect the range cable to the junction
box through the U.L.- or CSA-listed
conduit connector. Complete electrical
connection according to local codes and
mounting
screws ordinances.
7A.
Where local codes do not permit
connecting the frame-ground conductor
to the neutral (white) junction box wire
(also used for Canadian installations):
4-wire cable from power supply
red wires
bare or green
wires
4-wire cable from range
Ungrounded neutral
1. Disconnect power.
2. Connect the flexible, armored cable
from the range to the junction box
using a U.L.- or CSA-listed conduit
connector. Tighten screws on conduit
connector.
WARNING
Electrical Shock Hazard
junction box
white wires
twist-on
connector
black wires
U.L.- or CSA- listed
conduit connector
Figure 1
3. Connect the two black wires
together; and the two red wires
together using twist-on connectors.
(See Figure 1.)
4. Connect the two white wires
together using twist-on connector.
5. Connect the bare or green ground
wire from the range cable to the
grounded wire in the junction box or
other grounded connector using
twist-on connector. (See Figure 1.)
Do not connect bare ground wire to
neutral (white) wire in junction box.
7B.
Where local codes permit
connecting the frame-ground conductor
to the neutral (white) junction box wire
(not used for Canadian installations):
3-wire cable from
power supply
junction
box
red
wires
white
wire
white and bare
or green wires
4-wire cable from range
Grounded neutral
Figure 2
1. Disconnect power.
2. Connect the flexible, armored cable
from the range to the junction box
using a U.L.- or CSA-listed conduit
connector. Tighten screws on conduit
connector.
3. Connect the two black wires together;
the two red wires together; and the
bare or green and white cooktop cable
wires to the white (neutral) wire in the
junction box using twist-on
connectors. (See Figure 2.)
black
wires
U.L.- or CSA-
listed conduit
connector